MAX48A-32J02FE0650 1124112 Linear encoders: MAX SICK Products Motion control sensors Linear encoders > Motion control sensors > Linear encoders > MAX > MAX48A-32J02FE0650 CE|RCM|UKCA
| Items supplied | Accessories not included with delivery, please order separately. |
|---|---|
| MTTFD (mean time to dangerous failure) | 69 years (EN ISO 13849-1) 1) |
| Type | 48 mm installation housing – IN cylinder mounting |
| Pressure pipe/End cap | 10 mm / Flat |
| Connection type | Male connector, M12 type L (24×24 mm), 5-pin |
| Direction of connection | Axial |
| Measuring rangeMeasured valuesPositioningPosition (F.S.)0 mm … 650 mm 1)Null zone30 mmDamping zone63 mm | Measuring range |
| Measuring range | |
| Measured values | Positioning |
| Position (F.S.) | 0 mm … 650 mm 1) |
| Null zone | 30 mm |
| Damping zone | 63 mm |
| Operating conditionsFluid temperature–30 °C … +95 °C 2)Air humidity90 % (Condensation not permitted)Operating pressure PN400 barSupply voltage24 V DC (8 … 32 V DC)Switch-on time< 250 msSwitch-on currentTyp. 5.0 A / 50 µsMeasuring frequency (internal)1 msTransmission rate (cycle time)20 ms | Operating conditions |
| Operating conditions | |
| Fluid temperature | –30 °C … +95 °C 2) |
| Air humidity | 90 % (Condensation not permitted) |
| Operating pressure PN | 400 bar |
| Supply voltage | 24 V DC (8 … 32 V DC) |
| Switch-on time | < 250 ms |
| Switch-on current | Typ. 5.0 A / 50 µs |
| Measuring frequency (internal) | 1 ms |
| Transmission rate (cycle time) | 20 ms |
| AccuracyHysteresis± 0,1 mmRepeatabilityTyp. ± 0.2 mmLinearityTyp. ± 0.25 mm (measuring range 50 to 500 mm) 3)Typ. ± 0.04% F.S. (measuring range from 500 to 2,500 mm) | Accuracy |
| Accuracy | |
| Hysteresis | ± 0,1 mm |
| Repeatability | Typ. ± 0.2 mm |
| Linearity | Typ. ± 0.25 mm (measuring range 50 to 500 mm) 3) |
| Temperature driftWarming up phaseTyp. ≤ ± 0.25 mm (2 min)In the operational statusTyp. ± 0.25 mm (measuring range 50 to 500 mm) 3)Typ. ± 0.04% F.S. (measuring range from 500 to 2,500 mm) | Temperature drift |
| Temperature drift | |
| Warming up phase | Typ. ≤ ± 0.25 mm (2 min) |
| In the operational status | Typ. ± 0.25 mm (measuring range 50 to 500 mm) 3) |
| Communication interface | SAE J1939 |
| Address settingBaud rate250 kbit/sSource Adress02 | Address setting |
| Address setting | |
| Baud rate | 250 kbit/s |
| Source Adress | 02 |
| Network Management Protocol | SAE J1939-81 |
| Application Layer | SAE J1939-71 |
| PIN assignment | 1=n.c.; 2=V DC; 3=GND; 4=CAN_H; 5=CAN_L |
| Electrical operationSupply voltage24 V DC (8 … 32 V DC)Residual ripple< 1% S-SPower consumption≤ 0.75 WCurrent consumption≤ 30 mABus termination (external)120 Ω | Electrical operation |
| Electrical operation | |
| Residual ripple | < 1% S-S |
| Power consumption | ≤ 0.75 W |
| Current consumption | ≤ 30 mA |
| Bus termination (external) | 120 Ω |
| Overvoltage protection during power-up (60 s) | ≤ 36 V at all poles during power-up (60 s)≤ 48 V To GND during power-up (60 s) |
| Reverse polarity protection | ≤ 36 V (at all poles) (ISO 16750-2) |
| Insulation resistance | Riso ≥ 10 MΩ, 60 s (ISO 16750-2) |
| Dielectric strength | 500 V DC, 0 V DC (60 s) to housing (RISO ≥ 1 MΩ) (ISO 16750-2) |
| Short-circuit protection | VS – GND on housing |
| DimensionsHousing48 mm, 48f7 for IN cylinder mounting – cylinder bore hole 48H8Ø pressure pipe10 mmØ O-ring40.87 mm x 3.53 mmØ support ring42.6 mm x 48 mm x 1.4 mmM12 flangeM12 flange type L: DM 24×24 mm – hole pattern 17 mm (EN 61076-2-101)Wire length100 mm | Dimensions |
| Dimensions | |
| Housing | IP67 (EN 60529) |
| Ø pressure pipe | 10 mm |
| Ø O-ring | 40.87 mm x 3.53 mm |
| Ø support ring | 42.6 mm x 48 mm x 1.4 mm |
| M12 flange | Nickel-plated brass with O-ring (NBR) |
| Wire length | 100 mm |
| MaterialHousingStainless steel 1.4305 (AISI 303)Pressure pipeStainless steel 1.4404, AISI 316LO-ringNBR 70Support ringPTFEM12 male connectorGlass fiber reinforced polyamide, nickel-/gold-plated brass contactsM12 flangeNickel-plated brass with O-ring (NBR)StrandsPVC | Material |
| Material | |
| Pressure pipe | Stainless steel 1.4404, AISI 316L |
| O-ring | NBR 70 |
| Support ring | PTFE |
| M12 male connector | IP69K (ISO 20653) 3) |
| Strands | PVC |
| EMCEU Directive 2014/30 / EU CE markingGeneric standardsEN 61000-6-2/61000-6-3Agricultural and forestry machineryEN ISO 14982Transient pulsesISO 7637-2/ISO 16750-2ESD (air and contact discharge)ISO 61000-4-2 / ISO 10605 | EMC |
| EMC | EU Directive 2014/30 / EU CE marking |
| Generic standards | EN 61000-6-2/61000-6-3 |
| Agricultural and forestry machinery | EN ISO 14982 |
| Transient pulses | ISO 7637-2/ISO 16750-2 |
| ESD (air and contact discharge) | ISO 61000-4-2 / ISO 10605 |
| VibrationSine20 g (sine) / 55 … 2,000 Hz / 3×24 h (IEC 60068-2-6 Fc)Sine over noise18 g (r.m.s) / 10 … 2,000 Hz / 3×36 h (IEC 60068-2-80 Fi)Broadband noise (resonance peaks removed)20 g (r.m.s) / 10 … 2,000 Hz / 3×48 h (IEC 60068-2-64 Fh) | Vibration |
| Vibration | |
| Sine | 20 g (sine) / 55 … 2,000 Hz / 3×24 h (IEC 60068-2-6 Fc) |
| Sine over noise | 18 g (r.m.s) / 10 … 2,000 Hz / 3×36 h (IEC 60068-2-80 Fi) |
| Broadband noise (resonance peaks removed) | 20 g (r.m.s) / 10 … 2,000 Hz / 3×48 h (IEC 60068-2-64 Fh) |
| Pressure loadOperating pressure PN400 barOverload pressure Pmax = PN x 1.2480 barTest pressure Pstat = PN x 1.5600 bar | Pressure load |
| Pressure load | |
| Overload pressure Pmax = PN x 1.2 | 480 bar |
| Test pressure Pstat = PN x 1.5 | 600 bar |
| Temperature and air humidityStorage–20 °C … +65 °C 1)Operation (electronics)–40 °C … +105 °C 2)Maximum air humidity90 % (Condensation not permitted) | Temperature and air humidity |
| Temperature and air humidity | |
| Storage | –20 °C … +65 °C 1) |
| Operation (electronics) | –40 °C … +105 °C 2) |
| Maximum air humidity | 90 % (Condensation not permitted) |
| Enclosure ratingHousingIP67 (EN 60529)M12 male connectorIP69K (ISO 20653) 3) | Enclosure rating |
| Enclosure rating | |
| EU declaration of conformity | ✔ |
| UK declaration of conformity | ✔ |
| ACMA declaration of conformity | ✔ |
| Moroccan declaration of conformity | ✔ |
| China RoHS | ✔ |
| Information according to Art. 3 of Data Act (Regulation EU 2023/2854) | ✔ |
| ECLASS 5.0 | 27270705 |
| ECLASS 5.1.4 | 27270705 |
| ECLASS 6.0 | 27270705 |
| ECLASS 6.2 | 27270705 |
| ECLASS 7.0 | 27270705 |
| ECLASS 8.0 | 27270705 |
| ECLASS 8.1 | 27270705 |
| ECLASS 9.0 | 27270705 |
| ECLASS 10.0 | 27270705 |
| ECLASS 11.0 | 27270705 |
| ECLASS 12.0 | 27274304 |
| ETIM 5.0 | EC002544 |
| ETIM 6.0 | EC002544 |
| ETIM 7.0 | EC002544 |
| ETIM 8.0 | EC002544 |
| UNSPSC 16.0901 | 41111613 |
| header | value |
| Unit weight | 0.910 Kilograms |
| Net unit weight | 0.91 Kilograms |
| Unit volume | 10560 Cubic Centimetres (cm³) |
| Country of origin | Germany |
| EAN | 4047084501203 |
Reviews
There are no reviews yet.